Brownells Iberica - El mayor proveedor de accesorios para el Tiro, Piezas y herramientas del armero. España
076683290014 100060678
This 7.62x54R Two-Die Full Length Die Set is intended for reloading bottleneck cases, and consists of a Full-Length Sizer Die with an Expander-Decapping Unit, and a Seater Die with Bullet Seater Plug. The Full-Length Sizer Die brings the case to SAAMI minimum cartridge dimensions. It sizes the outside of the case, de-primes and expands the neck to accept the bullet. The die has vents to prevent case damage caused by trapped air and for excessive lubricant. Headspace is held to minimum tolerances to avoid changing the case body length during full length sizing. The included Seater Die has a built-in roll crimper to secure the bullet at the same time as it’s seated.
74.9 74.9 1 EUR
N.º de producto: 100060678
RCBS 7.62X54R FULL LENGTH DIE SET
Ref Fabricante: 29001 076683290014 Este Juego de Dos Dados de Longitud Completa 7.62x54R está diseñado para la recarga de cartuchos con cuello de botella, y consta de un Dado de Dimensionamiento de Longitud Completa con Unidad Expansora-Desencapsuladora, y un Dado de Asentamiento con Enchufe de Asentamiento de Bala. El Dado de Dimensionamiento de Longitud Completa lleva el casquillo a las dimensiones mínimas de cartucho SAAMI. Dimensiona el exterior del casquillo, desprimiza y expande el cuello para aceptar la bala. El dado tiene ventilaciones para evitar daños en el casquillo causados por aire atrapado y por exceso de lubricante. El espacio de cabeza se mantiene en tolerancias mínimas para evitar cambiar la longitud del cuerpo del casquillo durante el dimensionamiento completo. El Dado de Asentamiento incluido tiene un crimpiador de rollo incorporado para asegurar la bala al mismo tiempo que se asienta.
74.9 EUR 0 74,90 € *
No disponible.
Caracteristicas: Cartucho: 7.62x54R Tipo de die: Full Length Die Set

Atributos

Cartucho: 7.62x54R Tipo de die: Full Length Die Set Peso de entrega: 0,562kg Altura de envío: 38mm Ancho de envío: 114mm Longitud de envío: 152mm

Detalles del artículo

Hecho en USA



This 7.62x54R Two-Die Full Length Die Set is intended for reloading bottleneck cases, and consists of a Full-Length Sizer Die with an Expander-Decapping Unit, and a Seater Die with Bullet Seater Plug. The Full-Length Sizer Die brings the case to SAAMI minimum cartridge dimensions. It sizes the outside of the case, de-primes and expands the neck to accept the bullet. The die has vents to prevent case damage caused by trapped air and for excessive lubricant. Headspace is held to minimum tolerances to avoid changing the case body length during full length sizing. The included Seater Die has a built-in roll crimper to secure the bullet at the same time as it’s seated.
Newsletters