SHOTGUN BIG DOT TRITIUM FRONT SIGHT Highly visible, tritium dot front sight surrounded by a large white ring epoxies over the existing front bead sight to help improve target focus and low light sight acquisition and sight recovery after muzzle flash. Installs over front sight beads from .125' - .140' diameter by filling the cavity on the underside of the sight with Brownells Acraglas Gel, then pressing the sight over the bead and allowing it to fully cure. If existing bead is too small or too large, replace with Brownells #6 bead for 3-56 threads or #26 for 6-48 threads. Some shotgun barrels may require drilling and tapping of existing hole to 6-48 for installation of #26 Brownells bead. Vent Rib model with flat bottom fits shotgun barrels with ventilated ribs. Plain Barrel model with cupped bottom fits round shotgun barrels. Includes instructions. SPECS: Machined steel, black, matte finish. Big Dot .161” (4mm) diameter. Fits beads from .125” (3.2mm) to .140” (3.5mm). Vent Rib fits ventilated ribs. Plain Barrel fits round barrels. Includes instructions.
Mejora tu puntería con facilidad
SIGHT TRITIUM FRONTAL BIG DOT PARA ESCOPETA
El SHOTGUN BIG DOT TRITIUM FRONT SIGHT es una mira frontal de tritio altamente visible, rodeada por un gran anillo blanco, que se epoxida sobre la mira de bead frontal existente. Esto ayuda a mejorar el enfoque en el objetivo y la adquisición de la mira en condiciones de poca luz, así como la recuperación de la mira después de un destello del cañón.
Características del producto:
- Instalación sencilla sobre las miras de bead frontales de .125' - .140' de diámetro.
- Rellena la cavidad en la parte inferior de la mira con Brownells Acraglas Gel, presiona la mira sobre el bead y permite que cure completamente.
- Si el bead existente es demasiado pequeño o grande, reemplázalo con el bead #6 de Brownells para roscas 3-56 o #26 para roscas 6-48.
- Algunos cañones de escopeta pueden requerir perforar y roscar el agujero existente a 6-48 para la instalación del bead #26 de Brownells.
- Modelo de Vent Rib con fondo plano se adapta a cañones de escopeta con costillas ventiladas.
- Modelo de Plain Barrel con fondo acoplado se adapta a cañones redondos de escopeta.
Incluye instrucciones para una fácil instalación.
Especificaciones:
- Acero mecanizado, acabado negro mate.
- Big Dot de .161” (4mm) de diámetro.
- Se adapta a beads de .125” (3.2mm) a .140” (3.5mm).
- Vent Rib se adapta a costillas ventiladas.
- Plain Barrel se adapta a cañones redondos.
- Incluye instrucciones.