Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fit: Ruger Flattop Revolvers
Mejora tu precisión con el montaje EGW para tu revolver Ruger.
Simplemente quita la mira trasera de tu arma y reemplázala con el montaje EGW para poder instalar tu Vortex Razor, C-More RTS o STS. Puedes quitar el montaje y volver a colocar tu mira trasera en cualquier momento. Se incluye el hardware de montaje.
Instrucciones de instalación
- Quita la mira trasera*
- Instala el montaje EGW en el riel
- Ajusta el tornillo de fijación (si es aplicable)
- Coloca la mira de punto rojo sobre el montaje EGW (colocar un pequeño trozo de papel entre la mira de punto rojo y el montaje facilitará su extracción y evitará que el Loctite se adhiera a la mira).
- Aplica Loctite azul a los tornillos de montaje proporcionados
- Ajusta los tornillos de montaje a 15in/lbs
Los tornillos incluidos con este montaje requieren una llave allen de 5/64'' para la instalación. Este montaje no es compatible con: