RCBS Coated Neck Bushings are interchangeable to let the reloader select a bushing that gives precisely the right amount of tension on the bullet when using RCBS Gold Medal Match neck sizing dies. These bushings have a Tungsten Disulfide (WS2) anti-friction coating, so they do not require use to traditional case lube. Self-centering for proper alignment with case neck For best results, use of high-end brass with consistent neck thicknesses For use ONLY with RCBS Gold Medal neck sizing dies RCBS recommends having neck bushings one to two sizes above and below your target diameter (see note below). RCBS Coated Neck Bushings are a small but critical component in loading extremely consistent-shooting ammo with your Gold Medal Match sizing dies. Brownells Gun Tech™ Tip: There are two ways to select the steel neck bushings you need: (1) Measure the outside neck diameter of your loaded cartridge and subtract .002" to .003". This allows approximately .001" of brass to spring back for correct neck tension. (2) You can also measure the neck wall thickness of your case, multiply by two, add the diameter of your bullet and subtract .002" to .003".
Bushings de tamaño de cuello recubiertos de tungsteno para una recarga precisa.
Los RCBS Coated Neck Bushings son intercambiables, permitiéndote seleccionar un bushing que proporciona la tensión precisa sobre la bala al usar los dies de tamaño de cuello RCBS Gold Medal Match. Estos bushings cuentan con un recubrimiento de disulfuro de tungsteno (WS2) que reduce la fricción, por lo que no requieren el uso de lubricantes tradicionales para cartuchos.
Características:
- Auto-centraje para una alineación adecuada con el cuello del cartucho.
- Para obtener los mejores resultados, utiliza latas de alta calidad con espesores de cuello consistentes.
- Uso exclusivo con los dies de tamaño de cuello RCBS Gold Medal.
- RCBS recomienda tener bushings de cuello una a dos medidas por encima y por debajo de tu diámetro objetivo.
Los RCBS Coated Neck Bushings son un componente pequeño pero crítico para cargar munición que dispara de manera extremadamente consistente con tus dies de tamaño Gold Medal Match.
Consejo de Brownells Gun Tech™: Hay dos formas de seleccionar los bushings de acero que necesitas:
- Mide el diámetro exterior del cuello de tu cartucho cargado y resta .002" a .003". Esto permite aproximadamente .001" de retroceso del latón para una tensión correcta del cuello.
- También puedes medir el grosor de la pared del cuello de tu cartucho, multiplicar por dos, sumar el diámetro de tu bala y restar .002" a .003".