Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
¡Mejora tu puntería con el montura Trijicon RMR de EGW!
La montura BLANK TRIJICON RMR SIGHT MOUNT de EGW está diseñada para ofrecerte una instalación sencilla y segura de tu visor de punto rojo Trijicon RMR o Holosun HS507C. A continuación, te presentamos sus características y detalles de instalación:
Características del producto:
- Material: 7075 Aluminum
- Recubrimiento: Matte Black Hardcoat
- Longitud total: 1.780"
- Anchura total: 1.1"
- Hardware de montaje: (2) Tornillos de cabeza plana 6-32, (1) Tornillo de ajuste 6-32 X 3/16
- Compatibilidad: Trijicon RMR, Holosun HS507C
Este montaje es compatible con:
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
Este montaje no es compatible con:
Para instalar la montura, simplemente retira la mira trasera de tu arma y reemplázala con nuestra montura. No se requieren alteraciones y puedes quitar nuestra montura y volver a poner tu mira trasera en cualquier momento. El hardware de montaje está incluido.
Instrucciones de instalación:
- Retira la mira trasera*
- Instala la montura EGW en la ranura
- Ajusta el tornillo de ajuste (si es aplicable)
- Coloca el visor de punto rojo en la montura EGW (colocar un pequeño trozo de papel entre el visor y la montura facilitará su remoción y evitará que el Loctite llegue al visor).
- Aplica Loctite azul a los tornillos de montaje proporcionados
- Ajusta los tornillos de montaje a 15in/lbs
Nota: Los tornillos incluidos con esta montura requieren una llave allen de 5/64'' para la instalación.