"""""""""""EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This Mount Does Not Fit: CZ P10C Optics Ready CZ P10F Optics Ready
Mejora tu puntería con el montaje de visor EGW para CZ P10C/P10F.
El montaje de visor EGW está diseñado para facilitar la instalación de los visores de punto rojo Vortex Viper y Vortex Venom en tu pistola CZ P10C o P10F. Este montaje se instala de izquierda a derecha, con el cañón apuntando hacia adelante, y cuenta con un diseño de dovetail que facilita el proceso.
- Instrucciones de instalación:
- Retira la mirilla trasera de tu arma.
- Instala el montaje EGW en el dovetail.
- Ajusta el tornillo de fijación (si es aplicable).
- Coloca el visor de punto rojo sobre el montaje EGW (puedes poner un pequeño trozo de papel entre el visor y el montaje para facilitar su extracción y evitar que el Loctite se adhiera al visor).
- Aplica Loctite azul a los tornillos de montaje proporcionados.
- Ajusta los tornillos de montaje a 15 in/lbs.
Este montaje incluye:
- 2 tornillos de cabeza de botón - Proporcionados para visores Vortex Viper y Venom.
- 2 tornillos de cabeza plana - Proporcionados para visores Burris FastFire y Docter.
Los tornillos incluidos requieren una llave allen de 5/64'' para su instalación. Ten en cuenta que cualquier modificación en tu arma puede anular la garantía del fabricante.
Es recomendable que este producto sea instalado y revisado por un armero calificado. No se asume ninguna responsabilidad por daños o lesiones que puedan resultar de una instalación o uso inadecuado de este producto.
Este montaje no es compatible con:
- CZ P10C Optics Ready
- CZ P10F Optics Ready