EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount does not fit: Desert Eagle Post 2017 Baby Desert Eagle Post 2006 Please take note to the Pre 2017 and Post 2017 differences when placing your order. Pre 2017 rear shelf behind the dovetail is .187" Post 2017 rear shelf behind the dovetail is .120"
¡Mejora tu puntería con el montaje EGW para el Desert Eagle!
El montaje EGW para el Desert Eagle Pre 2017 es la solución perfecta para instalar tu Leupold DeltaPoint Pro de manera fácil y rápida. Diseñado para ser instalado de izquierda a derecha (con el cañón mirando hacia adelante), este montaje cuenta con una muesca que facilita su colocación.
Descripción del producto
Para instalar el montaje, simplemente sigue estos pasos:
- Retira la mira trasera de tu arma.
- Instala el montaje EGW en la muesca.
- Ajusta el tornillo de fijación (si corresponde).
- Coloca la mira de punto rojo sobre el montaje EGW. (Colocar un pequeño trozo de papel entre la mira y el montaje facilitará su retirada y evitará que el Loctite se adhiera a la mira).
- Aplica Loctite azul a los tornillos de montaje proporcionados.
- Ajusta los tornillos de montaje a 15 in/lbs.
Ten en cuenta que la modificación de tu arma puede anular la garantía del fabricante. Este producto debe ser instalado y verificado por un armero calificado. No se asume ninguna responsabilidad por daños o lesiones que puedan resultar de una instalación o uso inadecuado de este producto.
Compatibilidad
Este montaje no es compatible con:
- Desert Eagle Post 2017
- Baby Desert Eagle Post 2006
Nota: Presta atención a las diferencias entre Pre 2017 y Post 2017 al realizar tu pedido:
- La repisa trasera detrás de la muesca en Pre 2017 es de .187"
- La repisa trasera detrás de la muesca en Post 2017 es de .120"