EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Please take note to the Pre 2017 and Post 2017 differences. Pre 2017 rear shelf behind the dovetail is .187"" and Post 2017 is .120".
Mejora tu puntería con el montaje EGW para Desert Eagle.
El montaje EGW para el Desert Eagle Pre 2017 es la solución perfecta para instalar tus miras rojas Vortex Viper o Venom. Diseñado para facilitar la instalación, este montaje se coloca de izquierda a derecha (con el cañón hacia adelante).
Descripción del producto
Los puntos rojos EGW están diseñados para ser instalados fácilmente. Solo necesitas seguir estos pasos:
- Retira la mira trasera de tu arma.
- Instala el montaje EGW en la ranura.
- Ajusta el tornillo de fijación (si es aplicable).
- Coloca la mira roja en el montaje EGW. (Colocar un pequeño trozo de papel entre la mira roja y el montaje facilitará su remoción y evitará que el Loctite se adhiera a la mira.)
- Aplica Loctite azul a los tornillos de montaje proporcionados.
- Ajusta los tornillos de montaje a 15 in/lbs.
Contenido del paquete
- 2 tornillos de cabeza de botón - Proporcionados para las miras Vortex Viper y Venom.
- 2 tornillos de cabeza plana - Proporcionados para las miras Burris FastFire y Docter.
Los tornillos incluidos con este montaje requieren una llave allen de 5/64'' para la instalación. Ten en cuenta las diferencias entre Pre 2017 y Post 2017: la repisa trasera detrás de la ranura en Pre 2017 es de .187" y en Post 2017 es de .120".