EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Minor modification may be neccessary for Rock Islands. EGW products should be installed and checked by a qualified and competent gunsmith. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product. This mount fits (including but not limited to): Sig Sauer 1911 Stainless Super Target* Sig Sauer 1911 Match Elite* Sig Sauer 1911 Target Full Size* Sig Sauer 1911 Max Full Size* STI with adjustable rear sights STI Trojan STI DVC 3 Gun STI DVC Limited STI DVC Classic Springfield Range Officer Springfield Range Officer Elite Target Springfield Loaded Target Rock Island TCM Rock Target FS HC Combo 22TCM / 9MM Rock Island Pro Match ULtra 5” - 45 ACP Rock Island Pro Match Tac Ultra 6” - 45 ACP Rock Island Pro Match Ultra HC - 40S&W Rock Island Pro Match Ultra 6” - 10MM Rock Island Pro Match ULtra 6” HC - 10MM Iver Johnson Eagle XL-SS10 Iver Johnson Eagle SS-10 Iver Johnson Eagle O.D. Green Iver Johnson Eagle Coyote Tan Iver Johnson Eagle XL-10 Ported Iver Johnson Eagle XL-10 Iver Johnson Eagle XL-45 Ported Iver Johnson Eagle XL-45acp Iver Johnson Eagle LR
Montura LPA para Vortex Viper/Venom: la solución perfecta para tu 1911.
La montura LPA SIGHT para Vortex Viper/Venom es ideal para instalar en tu arma y asegurar tu visor de punto rojo. Con un diseño pensado para facilitar la instalación, esta montura es compatible con una variedad de modelos de 1911.
Descripción del producto
Las miras de punto rojo de EGW están diseñadas para ser instaladas de izquierda a derecha (con el cañón apuntando hacia adelante). La dovetail tiene un ángulo progresivo que permite una instalación más sencilla. Simplemente retira la mira trasera de tu arma y reemplázala con la montura EGW para montar tu Vortex Viper/Venom, Burris FastFire o Docter.
La montura se puede quitar y reemplazar con tu mira trasera en cualquier momento. El hardware de montaje está incluido. Puede ser necesaria una modificación menor para las Rock Islands. Los productos de EGW deben ser instalados y verificados por un armero calificado y competente.
Instrucciones de instalación
- Retira la mira trasera*
- Instala la montura EGW en la dovetail
- Ajusta el tornillo de fijación (si es aplicable)
- Coloca el visor de punto rojo en la montura EGW (colocar un pequeño trozo de papel entre el visor de punto rojo y la montura facilitará la extracción y evitará que el Loctite se adhiera al visor).
- Aplica Loctite azul a los tornillos de montaje proporcionados
- Aprieta los tornillos de montaje a 15in/lbs
Esta montura incluye:
- 2 tornillos de cabeza de botón - Proporcionados para Vortex Viper y Venom
- 2 tornillos de cabeza plana - Proporcionados para Burris FastFire y Docter
Los tornillos incluidos con esta montura requieren una llave allen de 5/64'' para la instalación.
Ten en cuenta que la modificación de tu arma puede anular la garantía del fabricante. Este producto debe ser instalado y verificado por un armero calificado. No se asume ninguna responsabilidad por daños o lesiones que puedan resultar de una instalación o uso inadecuado de este producto.
Compatibilidad
Esta montura es compatible (incluyendo, pero no limitado a):
- Sig Sauer 1911 Stainless Super Target*
- Sig Sauer 1911 Match Elite*
- Sig Sauer 1911 Target Full Size*
- Sig Sauer 1911 Max Full Size*
- STI con miras traseras ajustables
- STI Trojan
- STI DVC 3 Gun
- STI DVC Limited
- STI DVC Classic
- Springfield Range Officer
- Springfield Range Officer Elite Target
- Springfield Loaded Target
- Rock Island TCM Rock Target FS HC Combo 22TCM / 9MM
- Rock Island Pro Match Ultra 5” - 45 ACP
- Rock Island Pro Match Tac Ultra 6” - 45 ACP
- Rock Island Pro Match Ultra HC - 40S&W
- Rock Island Pro Match Ultra 6” - 10MM
- Rock Island Pro Match Ultra 6” HC - 10MM
- Iver Johnson Eagle XL-SS10
- Iver Johnson Eagle SS-10
- Iver Johnson Eagle O.D. Green
- Iver Johnson Eagle Coyote Tan
- Iver Johnson Eagle XL-10 Ported
- Iver Johnson Eagle XL-10
- Iver Johnson Eagle XL-45 Ported
- Iver Johnson Eagle XL-45acp
- Iver Johnson Eagle LR