Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Trijicon RMR red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs The screws that are included with this mount require a 5/64'' allen wrench for installation. This mount does not fits: S&W M&P S&W M&P 2.0 S&W M&P 22
¡Mejora tu puntería con el montaje de visor EGW!
El montaje S&W M&P SHIELD EZ TRIJICON RMR es la solución perfecta para instalar tu visor red-dot Trijicon RMR en tu S&W M&P SHIELD EZ. Simplemente quita la mira trasera de tu arma y reemplázala con el montaje EGW.
Descripción del producto
Con este montaje, podrás:
- Quitar fácilmente el montaje y volver a colocar tu mira trasera en cualquier momento.
- Incluir hardware de montaje para una instalación sencilla.
Instrucciones de instalación
- Retira la mira trasera*
- Instala el montaje EGW en el riel de la mira
- Ajusta el tornillo de fijación (si es aplicable)
- Coloca el visor red-dot sobre el montaje EGW (colocar un pequeño trozo de papel entre el visor red-dot y el montaje facilitará su extracción y evitará que el Loctite se adhiera al visor).
- Aplica Loctite azul a los tornillos de montaje proporcionados
- Ajusta los tornillos de montaje a 15in/lbs
Los tornillos incluidos con este montaje requieren una llave allen de 5/64'' para la instalación.
Nota importante
Este montaje no es compatible con:
- S&W M&P
- S&W M&P 2.0
- S&W M&P 22