Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mounts fits: Baby Desert Eagle (Post 2006) EAA Witness Elite Match This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Mejora tu puntería con el soporte de mira Trijicon RMR de EGW
El soporte de mira H&K VP9/40, P30, HK45 TRIJICON RMR de EGW está diseñado para ofrecerte la mejor experiencia de disparo. Hecho de materiales de alta calidad y fácil de instalar, este soporte es perfecto para tus necesidades de tiro.
Descripción del producto
- Material: Aluminio 7075
- Acabado: Matte Black Hardcoat
- Longitud total: 1.780"
- Anchura total: 1.1"
- Hardware de montaje: (2) Tornillos de cabeza plana 6-32, (1) Tornillo de ajuste 6-32 X 3/16
- Compatibilidad con punto rojo: Trijicon RMR, Holosun HS507C
Compatibilidad
Este soporte es compatible con:
- Baby Desert Eagle (Post 2006)
- EAA Witness Elite Match
No es compatible con:
Instrucciones de instalación
- Retira la mira trasera de tu arma.
- Instala el soporte de mira EGW en la dovetail.
- Ajusta el tornillo de ajuste (si aplica).
- Coloca la mira de punto rojo en el soporte EGW (colocar un pequeño trozo de papel entre la mira de punto rojo y el soporte facilitará la retirada y evitará que el Loctite se adhiera a la mira).
- Aplica Loctite azul a los tornillos de montaje proporcionados.
- Aprieta los tornillos de montaje a 15 in/lbs.
Los tornillos incluidos con este soporte requieren una llave allen de 5/64'' para la instalación.