EGW's Mosin Nagant mount allows you to remove the rear leaf sight and install the base without the need to unsolder anything. It is one of the most stable bases on the market and uses the rear sight housing so there are no major modifications to your rifle like with some other brands. Installation: Remove rear leaf sight from the housing Keep the original pin as you will need this to install the base Insert the tabbed side of our steel base in to the rear of the rear sight Check for fitment on the front of the steel base The corners and front may need to be filed down to achieve the optimal fit Once the base sits completely in the rear housing insert the retaining pin from the original sight Adjust the set screw to take up any play in the rail Screw the top aluminum mount to the steel base This mount can be put on in either direction EGW recommends measuring the hole spacing in your receiver to confirm it matches with the dimensions they have published. Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. EGW one-piece scope mounts are the obvious choice for hunters and tactical shooters alike. EGW machines these in thier shop using one of their machining centers. After machining, the mounts are tumbled, sand blasted, and Type III anodized for long lasting durability. Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is sold separately).
¡Mejora tu Mosin Nagant con este montaje de alta calidad!
El montaje Mosin Nagant de EGW te permite quitar la mira trasera y instalar la base sin necesidad de desoldar nada. Es una de las bases más estables del mercado y utiliza la carcasa de la mira trasera, por lo que no hay modificaciones importantes en tu rifle como ocurre con algunas otras marcas.
Instrucciones de instalación:
- Quita la mira trasera del alojamiento.
- Conserva el pasador original, ya que lo necesitarás para instalar la base.
- Inserta el lado con lengüeta de nuestra base de acero en la parte trasera de la mira trasera.
- Verifica el ajuste en la parte frontal de la base de acero.
- Es posible que las esquinas y la parte frontal necesiten ser limadas para lograr un ajuste óptimo.
- Una vez que la base esté completamente en el alojamiento trasero, inserta el pasador de retención de la mira original.
- Ajusta el tornillo de fijación para eliminar cualquier holgura en el riel.
- Atornilla el montaje de aluminio superior a la base de acero.
Este montaje se puede colocar en ambas direcciones. EGW recomienda medir el espaciado de los agujeros en tu receptor para confirmar que coincide con las dimensiones publicadas.
Las ranuras cruzadas Picatinny recorren toda la longitud del riel, lo que ofrece al tirador flexibilidad al montar anillas de mira y otros accesorios. El canal en el centro reduce la masa total del montaje. Además, en muchos casos, no obstruirá el uso de miras de hierro de fábrica. Los montajes de mira de una pieza de EGW son la elección obvia para cazadores y tiradores tácticos por igual.
EGW fabrica estos montajes en su taller utilizando uno de sus centros de mecanizado. Después del mecanizado, los montajes son pulidos, arenados y anodizados Tipo III para una durabilidad prolongada.
Recomendaciones de instalación:
EGW recomienda un par de 20 pulgadas-libras de torque y una gota de loctite azul (loctite se vende por separado).