Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.811" Overall Width: .99" Mounting Hardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw Red Dot Fitment: Vortex Viper/Venom, Burris FastFire, Crimson Trace CTS-1200, CTS-1300, Docter. FITS: Sig P210 Target (American Only Post 2016) EGW's red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with our mount in order to mount yourVortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation.
Mejora tu precisión con el montaje SIG SAUER P210A TARGET
El montaje SIG SAUER P210A TARGET VORTEX VIPER/VENOM SIGHT MOUNT de EGW es la solución perfecta para quienes buscan mejorar su puntería. Este montaje está diseñado específicamente para adaptarse a tu pistola Sig P210 Target (solo modelos americanos posteriores a 2016).
Descripción del producto
- Material: 7075 Aluminum
- Acabado: Matte Black Hardcoat
- Longitud total: 1.811"
- Anchura total: .99"
- Hardware de montaje:
- (2) Tornillos de cabeza de botón 6-32
- (2) Tornillos de cabeza plana 6-32
- (1) Tornillo de fijación 6-32
- Ajuste para punto rojo: Vortex Viper/Venom, Burris FastFire, Crimson Trace CTS-1200, CTS-1300, Docter.
Instrucciones de instalación
- Retira la mira trasera.
- Instala el montaje EGW en la ranura.
- Ajusta el tornillo de fijación (si es aplicable).
- Coloca el punto rojo en el montaje EGW (colocar un pequeño trozo de papel entre el punto rojo y el montaje facilitará la extracción y evitará que el Loctite se adhiera al punto rojo).
- Aplica Loctite azul a los tornillos de montaje proporcionados.
- Ajusta los tornillos de montaje a 15 in/lbs.
Detalles adicionales
Este montaje incluye:
- 2 Tornillos de cabeza de botón - Proporcionados para Vortex Viper y Venom Sights
- 2 Tornillos de cabeza plana - Proporcionados para Burris FastFire y Docter Sights
Los tornillos incluidos requieren una llave allen de 5/64'' para la instalación.