Simply remove the rear sight on your gun and replace it with EGW mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation.
¡Mejora tu puntería con el montaje EGW para tu revólver S&W!
Este montaje EGW es perfecto para instalar tu mira Vortex Viper/Venom, Burris FastFire o Docter en tu revólver S&W K, L, N o X Frame. Simplemente quita la mira trasera de tu arma y reemplázala con el montaje EGW. ¡Es fácil de instalar y puedes volver a colocar la mira trasera en cualquier momento!
Instrucciones de instalación:
- Quita la mira trasera*
- Instala el montaje EGW en la ranura del cañón
- Ajusta el tornillo de fijación (si aplica)
- Coloca la mira de punto rojo en el montaje EGW (colocar un pequeño trozo de papel entre la mira de punto rojo y el montaje facilitará la extracción y evitará que el Loctite se adhiera a la mira de punto rojo).
- Aplica Loctite azul a los tornillos de montaje proporcionados
- Ajusta los tornillos de montaje a 15in/lbs
Incluye:
- 2 tornillos de cabeza de botón - Proporcionados para las miras Vortex Viper y Venom
- 2 tornillos de cabeza plana - Proporcionados para las miras Burris FastFire y Docter
Los tornillos incluidos con este montaje requieren una llave allen de 5/64'' para la instalación.