Material: 7075 Aluminum Coating: Matte Black Hardcoat Overall Length: 1.780" Overall Width: 1.1" Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw Red Dot Fitment: Trijicon RMR, Holosun HS507C This mount does not fit: Rock Island 1911s Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Flat Head Cap Screws - Provided for Trijicon RMR The screws that are included with this mount require a 5/64'' allen wrench for installation.
Mejora tu puntería con el montura TRIJICON RMR para GLOCK®
La montura TRIJICON RMR de EGW es la solución perfecta para instalar tu mira red dot en tu GLOCK®. Fabricada en aluminio 7075 y con un acabado negro mate, esta montura combina durabilidad y estética.
Características del producto:
- Longitud total: 1.780"
- Ancho total: 1.1"
- Hardware de montaje: (2) tornillos de cabeza plana 6-32, (1) tornillo de ajuste 6-32 X 3/16
- Compatibilidad: Trijicon RMR, Holosun HS507C
- No es compatible con: Rock Island 1911s
Para instalar la montura, simplemente retira la mira trasera de tu arma y reemplázala con nuestra montura. No se requieren modificaciones y puedes quitar la montura en cualquier momento para volver a colocar tu mira trasera. El hardware de montaje está incluido.
Instrucciones de instalación:
- Retira la mira trasera*
- Instala la montura EGW en la muesca
- Ajusta el tornillo de ajuste (si es aplicable)
- Coloca la mira red dot en la montura EGW (colocar un pequeño trozo de papel entre la mira red dot y la montura facilitará la extracción y evitará que el Loctite se adhiera a la mira red dot).
- Aplica Loctite azul a los tornillos de montaje proporcionados
- Ajusta los tornillos de montaje a 15 in/lbs
Nota: Los tornillos incluidos con esta montura requieren una llave allen de 5/64'' para la instalación.